M-100 Wind Turbine
Generator
Rated Power: 100 Kw at approximately 35 mph
Type: 3 phase, 60 Hz synchronous 480 VAC
RPM: 1200 (3 phase)
Monopole Tower
Construction material; Hot dipped galvanized steel plate
Height 75 ft
Hub height: 78 ft
White colored paint coating
Nacelle acess: interior tower ladder through locked door
Base Diameter: . 6’ 5”
Control Panel located inside bottom of tower
Rotor
Orientation: Upwind
3 blades, fixed pitch
71’6” diameter
Blades
Aerostar 10 meter
Fiberglass
Weight – approx. 1700 lbs.
Area swept: 4,020 sqf
Centrifugal blade –tip brakes
Component Weights
Nacelle, Bedplate, Rotor and blades: 15,700 lbs
Tower (3 sections): 16,800
Operational
Cut in speed: 11mph
Cut-off speed: None (stall regulated blades)
Survival wind speed: 120 mph
Other
New elecronic controls panel
New Wiring
Options
Internet accessibility
Heated wind vane
Transmission heater
Noise damping foam installed
Safety Features
Induction generator anti-islanding
Fail safe hydraulic disk brake
Blade over speed centrifugally actuated tip brakes
Thermal protectin on generator
Thermal protection for yaw controls
Vibration sensor for fault shutdown
| Turbine | M-100 |
| 3 Phase | |
| Power Output kWh | |
| 40% Production | 455,520 |
| 30% Production | 341,640 |
| Income 40% Production | |
| $.04 per kWh | $18,220 |
| .05 | 22,776 |
| .06 | 27,331 |
| .07 | 31,886 |
| .08 | 36,441 |
| .09 | 40,997 |
| .10 | 45,552 |
| Income 30% Production | |
| $.04 per kWh | $13,665 |
| .05 | 17,062 |
| .06 | 20,498 |
| .07 | 23,914 |
| .08 | 27,331 |
| .09 | 30,747 |
| .10 | 34,164 |
| Income Production Tax Credits $0.021 | |
| 40% Production | 9,566 |
| 30% Production | 7,175 |
| Prices subject to change based on turbine availability |
» All New, State-of the-art Power Electronics
» Tubular Monopole Tower
» Interior Ladder Access
Refurbishment Information
Refurbishment process includes inspection and replacement of all parts necessary.
Generator is re-wound and bearings are replaced (Auxilary cooling fan installed)
Gearbox has all seals and bearings replaced with new oil. Gears and shafts thoroughly inspected and replaced if needed
The hydraulic brake units are rebuilt and tested, switches are replaced also includes new brake pads.
Yaw motor is replaced, bearing and seals replaced. Yaw gear is replaced.
Slew ring is remanucatured or replaced.
The main shaft bearings and seals are checked and replaced if necessary.
The main shaft is ultra sound tested and checked for run out, and replaced if standard not met.
Wiring and Old electronics are replaced
The blades are inspected, repaired/remanucatured, balanced and matched as a set.
The blade tips are remanufactured springs tested and alll bearing and cams replaced
Tower is degreased, safety stops installed and painted.
Nacelle is degreased and painted and additional air inlets installed.