M-100 Mid Sized Wind Turbine Specifications

Generator

Rated Power: 100 Kw at approximately 35 mph
Type: 3 phase, 60 Hz synchronous 480 VAC
RPM: 1200 (3 phase)

Monopole Tower

Construction material; Hot dipped galvanized steel plate
Height 75 ft
Hub height: 78 ft
White colored paint coating
Nacelle acess: interior tower ladder through locked door
Base Diameter: approx. 6.25 ft
Control Panel located inside bottom of tower

Rotor

Orientation: Upwind
Aerostar 10 meter
3 blades, fixed pitch
71’6” diameter

Blades

Fiberglass
Weight – approx. 1700 lbs.
Area swept: 4,020 sqf
Centrifugal blade –tip brakes
Refurbishment process includes inspection and replacement of all parts necessary.
Generator is re-wound and bearings are replaced (Auxilary cooling fan installed)
Gearbox has all seals and bearings replaced with new oil. Gears and shafts thoroughly inspected and replaced if needed.
The magnetic brake units are tested, switches replaced, magnets tested or replaced, new boots, new brake pads.
Yaw motor is replaced, bearing and seals replaced. Yaw gear is replaced.
Slew ring is remanucatured or replaced.
The main shaft bearings and seals are checked and replaced if necessary.
The main shaft is ultra sound tested and checked for run out, and replaced if standard not met.
Wiring and Old electronics are replaced
The blades are inspected, repaired/remanucatured, balanced and matched as a set.
The blade tips are remanufactured springs tested and all bearing and cams replaced
Tower is degreased, safety stops installed and painted.
Nacelle is degreased and painted and additional air inlets installed.

M-100 (2 year parts and labor warranty, Service included in warranty cycle, travel not included)	_________
Installation	_________
Travel and Expenses from Otis, Ks)	_________
Foundation (typical)	_________
Electrical (depending on placement) to handle 300 amps	_________

Component Weights

Nacelle, Bedplate, Rotor and blades: 15,700 lbs
Tower (3 sections): 16,800

Operational

Cut in speed: 11mph
Cut-off speed: None (stall regulated blades)
Survival wind speed: 120 mph

Other

New elecronic controls panel
New Wiring

Options

Internet accessibility
Heated wind vane
Transmission heater
Noise damping foam installed

Safety Features

Induction generator anti-islanding
Fail safe hydraulic disk brake
Blade over speed centrifugally actuated tip brakes
Thermal protectin on generator
Thermal protection for yaw controls
Vibration sensor for fault shutdown

Turbine	M-100
	3 Phase
Power Output kWh
40% Production	455,520
30% Production	341,640

Income 40% Production
$.04 per kWh	$18,220
.05	22,776
.06	27,331
.07	31,886
.08	36,441
.09	40,997
.10	45,552
Income 30% Production
$.04 per kWh	$13,665
.05	17,062
.06	20,498
.07	23,914
.08	27,331
.09	30,747
.10	34,164
Income Production Tax Credits $0.019
40% Production	8,655
30% Production	6,491
Prices subject to change based on turbine availability
Unit Price	Call For Pricing

M-130 Wind to Energy Chart

Extended Warranty 3 year or 5 year total (7% or 15% of purchase price payable on purchase of turbine.)

Terms 50% down payment at purchase. Additional 25% plus foundation cost at completion of foundation, final 25% payment including travel and expenses at project completion.